Frank91608
New Member
Hi,
I'm new to the Picaxe and have been having fun learning. I came across a couple of things that have me stumped. I have the o8m starter kit and I would like to have it connected to a small sound board (http://www.electronics123.com/s.nl/it.A/id.499/.f?sc=8&category=2) I just can't figure out how to connect it to the board. I set pin2 to high and when it's connected to the +v on the sound board it cycles the power to it on and off but if I connect an LED it stays lit.
Also, I would like a switch to start the program so I set up and if/then command so when pin3=1 it starts and 0 nothing happens, but as soon as power is applied it starts. In the simulator it works like it should but not on the actual board.
Hope these aren't really stupid questions, thank you for any help you may provide.
I'm new to the Picaxe and have been having fun learning. I came across a couple of things that have me stumped. I have the o8m starter kit and I would like to have it connected to a small sound board (http://www.electronics123.com/s.nl/it.A/id.499/.f?sc=8&category=2) I just can't figure out how to connect it to the board. I set pin2 to high and when it's connected to the +v on the sound board it cycles the power to it on and off but if I connect an LED it stays lit.
Also, I would like a switch to start the program so I set up and if/then command so when pin3=1 it starts and 0 nothing happens, but as soon as power is applied it starts. In the simulator it works like it should but not on the actual board.
Hope these aren't really stupid questions, thank you for any help you may provide.