david miles
Member
Hello Group.
I am not too good at digital stuff, but I will try to explain my problem. I am inputing into axe110 datalogger on analogue input 1, a voltage of approximately 0.500 volts, which can increase by + or - 0.001volts each second. I have an axe 033 lcd module attached, but this is reading 38 !!!. I am using a picaxe wizard programme to record readings each second.
My question is, can I get my lcd module to display 0.500, 0.501 etc with an appropriate programme, or should I amplify my output before I feed it into my datalogger sensor input? Anyone any ideas?
David Miles.
I am not too good at digital stuff, but I will try to explain my problem. I am inputing into axe110 datalogger on analogue input 1, a voltage of approximately 0.500 volts, which can increase by + or - 0.001volts each second. I have an axe 033 lcd module attached, but this is reading 38 !!!. I am using a picaxe wizard programme to record readings each second.
My question is, can I get my lcd module to display 0.500, 0.501 etc with an appropriate programme, or should I amplify my output before I feed it into my datalogger sensor input? Anyone any ideas?
David Miles.