everything is fine , converts flow chart to basic, can select micro type but when it comes to target pic it only has pic16f872 as a 28 pin, assembles ok but then states pic not found when attempting to program pic, obviously as it is looking for pic16f872.
When using program pic, i can choose the 16f76 and read the chip, i dont yet know how to look at the data it reads of the chip yet,
I do get an error message when verifying the cip, error as follows...byte$2007 low is $a0 should be S80 high is $3f should be $3f. When checking the chip is blank it says it is not, when trying to erase the chip it just comes up failed check pic is inserted correctly...how do i include this chip so it targets it instead of 16f872, any help gratefully recieved