To,HIPPY and others forum members
RE CMPS14 Compass Problem
I have found the fault that was causing No Response to Acquisition Code
I had removed the Terminal Pin Assembly so that I could fit it into
my PCB and Case.
I had inspected the connections when I removed the Terminals,
but under a HIGH...
Sorry if this is classed as new thread
Re CMPS14
Thanks to Hippy and others re problems with CMPS14
much appreciated!!
I have decided to use the CMPS14 I2C Interface using
"14M2 and I2C Interface."
also incorporating a 9600 Serial Port to an OpenLog Card Logger...
New Thread Re CMPS14 Compass
Compass was working very well into terminal
This compass is highly accurate
Now getting Timedout in terminal
Tried several 08M2 and 2 Compass Modules
Checked Terminal and Downloads OK
;Latest Iteration of CMPS14 compass test
;with Great Help from "Hippy'
#Picaxe...
Hippy results of Test CMPS14
I have the compass working,, and need to connect to Open Log Card Logger
Open Log requires serial output @ 4800,8,n,1
I am thinking of using C.3 for this purpose and would appreciate any help in this regard...
Found Dry joint in wiring to Compass
Have now repaired same and things looking a lot better
Terminal appears to register directions.
I will continue with your help!! which is much appreciated
I would like to be able to send direction data to an Open Log instead of the terminal
I have 2 ports...
#picaxe 08m2
#terminal 4800
#no_data
main:
for b1=1 to 2
sertxd ("the value of b1 is ",#b1,13,10);Terminal
b1=b1+1
next b1
;#Picaxe 08M2
#Terminal 4800
; --CMPS14 COMPASS CONNECTIONS----
;CMPS14 Power Supply is 3.6V
;CMPS14 MODE PIN is Connected to 0V to Enable Serial Data Transfer
Symbol...
Hi,
On Sept. 11th I posted for -Software to read CMPS14 Compass Data for
which I am very grateful?
I have been back in hospital and have just now returned to this project.
with short term memory loss?
The code I was given at the time has me a little confused
I am using 08M2
and the software...
I am an oldie just trying to resurrect my knowledge
I have CMP14 Compass module with serial function @9600bps
I will be using 08M2 Chip @ 3.3V
Compass requires the command of 0x13 to be sent to the Compass @9600bps
I would need to put this in a timed loop to get compass bearing data regularly...