Hello,
I was hoping to buy a set of xbee wireless modules, basically to make a remote control for a robot.
I need quite a lot of outputs to control servos, (minimum 8). When i looked at the manual for connecting more than one picaxe together, it was talking about connecting together using serial to get more outputs.
I don't want to transmit back from the robot, just control it.
Can i just simply run a jumper from the serial out pin (on the picaxe from the recieving module) and use the method in the manual?
My idea was that if i was simply controlling it, to not use any serin commands on the transmitter.
Would this work?
I was hoping to buy a set of xbee wireless modules, basically to make a remote control for a robot.
I need quite a lot of outputs to control servos, (minimum 8). When i looked at the manual for connecting more than one picaxe together, it was talking about connecting together using serial to get more outputs.
I don't want to transmit back from the robot, just control it.
Can i just simply run a jumper from the serial out pin (on the picaxe from the recieving module) and use the method in the manual?
My idea was that if i was simply controlling it, to not use any serin commands on the transmitter.
Would this work?