Hello,
I have an 18X hooked up to a picaxe connect board with an xbee modem, and another connect board hooked to my computer through the download cable. I am trying to send readings from an accelerometer, which is attached to the picaxe, to the computer so I can log them, but I am running into problems. When I run this program:
main:
serout 7,T2400,("HELLO",CR,LF)
pause 2000
goto main
and listen with my computer, it happily reads in HELLO over and over again complete with line breaks.
However, when I put the same serout command into the program that reads the accelerometer, it happily reads Zøtt:ºZø over and over again with no line breaks at all. Between the two programs, I didn't change any hardware, I just downloaded a new program. Does anyone have any idea what is happening?
thanks
I have an 18X hooked up to a picaxe connect board with an xbee modem, and another connect board hooked to my computer through the download cable. I am trying to send readings from an accelerometer, which is attached to the picaxe, to the computer so I can log them, but I am running into problems. When I run this program:
main:
serout 7,T2400,("HELLO",CR,LF)
pause 2000
goto main
and listen with my computer, it happily reads in HELLO over and over again complete with line breaks.
However, when I put the same serout command into the program that reads the accelerometer, it happily reads Zøtt:ºZø over and over again with no line breaks at all. Between the two programs, I didn't change any hardware, I just downloaded a new program. Does anyone have any idea what is happening?
thanks