I got a picaxe 8, I am running 2 output pins to alternating pulsing Leds
Off each output pin I have one 2n2222.
One side is going to 10, 3.3volt leds and the other side is going to 6, 2.0v leds.
the 2.0v leds resistors are 39ohm on 2 parallel
the 3.3v leds resistors are 68 ohm to each led
When I power it up it flashes slowly one output for about 6 times then everything fires up and runs the way it should. Its like the chip is gathering power but that does not make sense.
I am NOT an electronics guru so be gentle on me if its something easy.
Off each output pin I have one 2n2222.
One side is going to 10, 3.3volt leds and the other side is going to 6, 2.0v leds.
the 2.0v leds resistors are 39ohm on 2 parallel
the 3.3v leds resistors are 68 ohm to each led
When I power it up it flashes slowly one output for about 6 times then everything fires up and runs the way it should. Its like the chip is gathering power but that does not make sense.
I am NOT an electronics guru so be gentle on me if its something easy.