michael boyd
Member
Hi
The problem I am having is that whenever one of the motors run (conveyer or cup dispenser, it activates the servo program operating the servos (crane)
http://www.youtube.com/watch?v=oPUkO93n0bU&feature=channel
Hand drawn diagram attached, sorry a bit messy
Originally, I was not using the batteries, and would rather not. But I did think this would fix the problem by completely isolating.
The inputs are controlled by microswitches which are piggybacked, one for the 20M and the other for the SD21 board (this is fitted with an 18X chip), see photo.
It must be (I think) noise interference caused by the motor, however up to date have not being able to fix it
Any ideas?
regards
michael
The problem I am having is that whenever one of the motors run (conveyer or cup dispenser, it activates the servo program operating the servos (crane)
http://www.youtube.com/watch?v=oPUkO93n0bU&feature=channel
Hand drawn diagram attached, sorry a bit messy
Originally, I was not using the batteries, and would rather not. But I did think this would fix the problem by completely isolating.
The inputs are controlled by microswitches which are piggybacked, one for the 20M and the other for the SD21 board (this is fitted with an 18X chip), see photo.
It must be (I think) noise interference caused by the motor, however up to date have not being able to fix it
Any ideas?
regards
michael
Attachments
-
211.8 KB Views: 42
-
269.4 KB Views: 63