I want to use a 9g micro servo driven by a Picaxe-14M to control a stub N-Scale 3way turnout.
While the two endpoints are position repeatable the center is not due to servo backlash(?). If I approach the center position from the same direction the position is repeatable. Is there any way around this?
Here is my code which reads a 1 pole 3 position switch and uses case statements. The highs out control relays that provide correct track polarity to the three frogs.
Thanks for any help or new code.
While the two endpoints are position repeatable the center is not due to servo backlash(?). If I approach the center position from the same direction the position is repeatable. Is there any way around this?
Here is my code which reads a 1 pole 3 position switch and uses case statements. The highs out control relays that provide correct track polarity to the three frogs.
Thanks for any help or new code.
Last edited: