I have a reliable wireless link using a low cost transmitter and receiver pair running at 1200baud using serin and serout. I recently bought some 18M2 devices and experimented with the RFout and RFin commands.
With the two chips connected on the bench with a wire, no problems. When I use the transmitter and receiver pair I get very poor results. After measuring the received output I think that the data rate is too fast for this Tx and Rx pair.
Is there a way to change the baud rate for RFout and RFin?
With the two chips connected on the bench with a wire, no problems. When I use the transmitter and receiver pair I get very poor results. After measuring the received output I think that the data rate is too fast for this Tx and Rx pair.
Is there a way to change the baud rate for RFout and RFin?