Hello PICAXE world
Been testing and learning this new VSM and there is this one basic function that don't seem to work for me.
Made simple ADC test circuit. Move potentiometer and there should be three leds going on and off. But.... That simulation don't read adc value to memory.... grrrr.
1. Simulation don't but anything to W0
2. Can't find the place where i can seen whats in the memory while simulating?
3. Can you give your own b-w values to simulation-memory? Where?
Thanks for little advice
---------------- 2hours later
Been reading posting.... Problem was battery power source. Right one was terminal. It started to work after that.
Been testing and learning this new VSM and there is this one basic function that don't seem to work for me.
Made simple ADC test circuit. Move potentiometer and there should be three leds going on and off. But.... That simulation don't read adc value to memory.... grrrr.
1. Simulation don't but anything to W0
2. Can't find the place where i can seen whats in the memory while simulating?
3. Can you give your own b-w values to simulation-memory? Where?
Thanks for little advice
---------------- 2hours later
Been reading posting.... Problem was battery power source. Right one was terminal. It started to work after that.
Attachments
-
103.3 KB Views: 7
-
388 bytes Views: 11
Last edited: