tommo_NZ
New Member
I have a problem getting a 'pwmout' command to work on an 18x Picaxe chip.
e.g. "pwmout 3 , 99, 200"
It only works when followed by, and for the length of a pause command.
I understood it should work continuously in the background until a command
such as "pwmout 3,off" is issued.
I see BeanieBot remarked (see thread entitled 'Help building rc speed controller with picaxe 18x') that the pwm output pin on an 18x chip is output 1, but I have checked the manual and even the editor won't let you set it to any other than output 3.
Am I missing the point here?
tommo_nz
e.g. "pwmout 3 , 99, 200"
It only works when followed by, and for the length of a pause command.
I understood it should work continuously in the background until a command
such as "pwmout 3,off" is issued.
I see BeanieBot remarked (see thread entitled 'Help building rc speed controller with picaxe 18x') that the pwm output pin on an 18x chip is output 1, but I have checked the manual and even the editor won't let you set it to any other than output 3.
Am I missing the point here?
tommo_nz