robrandall
New Member
Hi. I am new to Picaxe and electronics in general. I am trying to get the AXE213 kit working.
The transmitter board will flash its LED correctly in test mode but I cannot get anything happening on the receiver board.
Using 2 Raspberry Pi's I have confirmed the transmitter and receiver modules are working. Using the RCSwitch library I can send and receive codes, and even send and receive from my 433MHz doorbell.
Can anyone advice on any tests I can do? Should a Raspi with a receiver module receive anything from the Picaxe transmitter board to check that side of things?
I realise that the Picaxe is using Manchester code so the RCSwitch software may not detect it.
All my soldering 'looks' ok, and the LED on the receiver is working.
Thanks,
Rob
The transmitter board will flash its LED correctly in test mode but I cannot get anything happening on the receiver board.
Using 2 Raspberry Pi's I have confirmed the transmitter and receiver modules are working. Using the RCSwitch library I can send and receive codes, and even send and receive from my 433MHz doorbell.
Can anyone advice on any tests I can do? Should a Raspi with a receiver module receive anything from the Picaxe transmitter board to check that side of things?
I realise that the Picaxe is using Manchester code so the RCSwitch software may not detect it.
All my soldering 'looks' ok, and the LED on the receiver is working.
Thanks,
Rob