If you first run this code, you will get “b1 = 22”
if b0 = 0 then poke 200, 22
endif
peek 200, b1
sertxd("b1 = ",#b1,cr,lf)
Then disconnect the power for a second, and then apply back the power and you will get “b1 = 22”
Now enter in this code and run it, and you still will get “b1 = 22”.
if b0 = 1 then poke 200, 22 'only b0 = 1 has been changed
endif
peek 200, b1
sertxd("b1 = ",#b1,cr,lf)
But when you now disconect the power for a second, and then apply back the power you will get “b1 = 4”
This was done on 28X Ver. 7.8 chip
Edited by - erdc on 02/03/2007 15:28:13
if b0 = 0 then poke 200, 22
endif
peek 200, b1
sertxd("b1 = ",#b1,cr,lf)
Then disconnect the power for a second, and then apply back the power and you will get “b1 = 22”
Now enter in this code and run it, and you still will get “b1 = 22”.
if b0 = 1 then poke 200, 22 'only b0 = 1 has been changed
endif
peek 200, b1
sertxd("b1 = ",#b1,cr,lf)
But when you now disconect the power for a second, and then apply back the power you will get “b1 = 4”
This was done on 28X Ver. 7.8 chip
Edited by - erdc on 02/03/2007 15:28:13