jensmith25
Senior Member
This might be a bit of an unusual one but I have a macBook Pro and so use the MacAxe software and have no problems at all with programming the 08m2 chips.
With the 18m2 I quite often have to try several times to get it to programme, despite it working fine just before and it's also associated with either the USB ports stopping working after a programming/testing session, or it fails to recognise the USB port and I have to use my other port or if both have failed, reboot my mac and start again.
This is getting pretty frustrating and I wondered if anyone else had had the same problem or knew what the cause might be.
With the 18m2 I quite often have to try several times to get it to programme, despite it working fine just before and it's also associated with either the USB ports stopping working after a programming/testing session, or it fails to recognise the USB port and I have to use my other port or if both have failed, reboot my mac and start again.
This is getting pretty frustrating and I wondered if anyone else had had the same problem or knew what the cause might be.