Jeremy Harris
Senior Member
I can't see anything in the manual or the online help about slowing the clock further (say, setfreq M2) and whether this then allows 300 baud as the minimum, rather than 600 baud with a 4MHz clock which is as slow as I can go according to the manual.
I'm not in a position to do a quick and dirty test right now, with things screwed to the wall, but I'm getting very occasional data errors at 600 baud and reckon that slowing to 300 baud may well fix it.
Can anyone confirm that changing the clock to, say, setfreq M2 and then changing the baud rate to T600_2, would be valid, please?
EDITED TO ADD:
I've found the answer - it's NO, there doesn't seem to be a way to go below 600 baud as PE throws up a syntax error if you do (I'm using M2 Picaxes).
I'm not in a position to do a quick and dirty test right now, with things screwed to the wall, but I'm getting very occasional data errors at 600 baud and reckon that slowing to 300 baud may well fix it.
Can anyone confirm that changing the clock to, say, setfreq M2 and then changing the baud rate to T600_2, would be valid, please?
EDITED TO ADD:
I've found the answer - it's NO, there doesn't seem to be a way to go below 600 baud as PE throws up a syntax error if you do (I'm using M2 Picaxes).
Last edited: