Hello everyone,
I am a total newcomer to the PICAXE Microcontroller world and to this forum.
I have an AXE020 Project Board fitted with a PICAXE -28X2.
With the board powered up using the common 5v link what output pin voltages should I expect to see when set by the program to 0 using the command letpinsB = %00000000.
I seem to have a higher voltage on pin B.0 than the others. Is this normal?
The voltage in question (0.6v) is enough to turn a relay on even though the output pin is supposed to be low.
Any help will be much appreciated.
Alan
I am a total newcomer to the PICAXE Microcontroller world and to this forum.
I have an AXE020 Project Board fitted with a PICAXE -28X2.
With the board powered up using the common 5v link what output pin voltages should I expect to see when set by the program to 0 using the command letpinsB = %00000000.
I seem to have a higher voltage on pin B.0 than the others. Is this normal?
The voltage in question (0.6v) is enough to turn a relay on even though the output pin is supposed to be low.
Any help will be much appreciated.
Alan