twisted wire
Active member
I'm having trouble reading ADC, this time it's getting the debug table to show anything other than what is set (Default?) on the adjust analogue value facility in the simulate mode?
Also, the program doesn't seem to run except in simulation mode?
I wrote a simple 'test' to try and understand what I'm doing wrong - which hasn't helped at all........
Below is the test program:
Start:
readadc C.1,B1
pause 10
debug B1
pause 10
goto start
If anyone has any patience left for me, I'd be grateful for any advice
Also, the program doesn't seem to run except in simulation mode?
I wrote a simple 'test' to try and understand what I'm doing wrong - which hasn't helped at all........
Below is the test program:
Start:
readadc C.1,B1
pause 10
debug B1
pause 10
goto start
If anyone has any patience left for me, I'd be grateful for any advice