Technoman
Senior Member
Hi,
While testing a flowchart in simulation mode aimed at checking a 28X1 (enclosed).
When you right click an analog input (e.g. A.0) to set-up a value, the zero value is not properly read. It's keeps any previous value.
When you try to adjust to 255, if you go just a little further with the cursor, it suddenly goes to zero...
View attachment Programme de test Autoprog v1-0.plf
While testing a flowchart in simulation mode aimed at checking a 28X1 (enclosed).
When you right click an analog input (e.g. A.0) to set-up a value, the zero value is not properly read. It's keeps any previous value.
When you try to adjust to 255, if you go just a little further with the cursor, it suddenly goes to zero...
View attachment Programme de test Autoprog v1-0.plf