hi,
I have the 28a starter kit. all is working fine. I'm trying to use the readadc command. I have a 10k potentiometer, it has 3 wires going out of it. I'm trying to understand where each of them should be connected to the kit analog "input" ribbon when trying to readadc from analog input 0 for example.
I measured the potentiometer itself independent of the board and it gives correct values when turning it.
I would add that I'm using an external supplier for other outputs in my system, (took the little dip switch out).
any help mostly appriciate.
--tzurs.
I have the 28a starter kit. all is working fine. I'm trying to use the readadc command. I have a 10k potentiometer, it has 3 wires going out of it. I'm trying to understand where each of them should be connected to the kit analog "input" ribbon when trying to readadc from analog input 0 for example.
I measured the potentiometer itself independent of the board and it gives correct values when turning it.
I would add that I'm using an external supplier for other outputs in my system, (took the little dip switch out).
any help mostly appriciate.
--tzurs.