ADC input to PICAXE simulator

[eagre]

When using the simulator facility of the PICAXE programming editor, how does one simulate analog inputs to ADC pins?

Ed

 

[Andres Rodriguez]

There is a set of four left and right arrows just below the RST button. Each set will simulate an input to ADC pins 0 to 3. The arrows allow you to place values (between 0 and 255) for each of the inputs in increments of 5. If you are using readadc10 it will take any value you enter with the arrows at the bottom (up to 1023)
Hope this helps
Andres Rodriguez

 

Edited by - marmitas on 19/04/2007 05:07:18

 

[eagre]

Marmitas -

Thanks a lot.

Ed