beastarella
New Member
Hi, just tried out a 28X1 in my nixie clock kits, seems the pins=X problem is still there? The program loads the time from a DS1307, and send it to the output port as a single byte using commands like pins=b0, but it seems that bit 7 (pin 28 on the picaxe) is always high regardless of what it should be, so of course the clock displays meaningless times.
I thought the pins= problem had been fixed? I am running PE V5.1.3 but the picaxe firmware is A.0, the problematic one. I have tried this on 2 chips, the problem is identical on both.
Is there a simple work-around for this? From what I have read in the forums, this was supposed to be fixed with a PE workaround in V5.1.1?
Any info would be greatly appreciated, I would actually like to be able to use these chips in somethign!
I thought the pins= problem had been fixed? I am running PE V5.1.3 but the picaxe firmware is A.0, the problematic one. I have tried this on 2 chips, the problem is identical on both.
Is there a simple work-around for this? From what I have read in the forums, this was supposed to be fixed with a PE workaround in V5.1.1?
Any info would be greatly appreciated, I would actually like to be able to use these chips in somethign!