I'm a bit confused around the pwm and hpwm commands and the 14m.
The pin out and appendix for advance use shows PWM2 on pin C5.
In my simplistic way I would assume that there should be a PWM0 and a PWM1 as well but this is not shown. The data says that.......
"C5 can be used with the pwmout command, but will make this pin an output.
Pins C2-5 (hpwm A-D) can all be used with the hpwm command, but will also
make the corresponding pins outputs"
So I suppose my question is "what's the difference between PWM and HPWM and could I use a 14M to drive a small motor one way and then the other using pwm on two of these outputs" ?
Rgds,
Sid
The pin out and appendix for advance use shows PWM2 on pin C5.
In my simplistic way I would assume that there should be a PWM0 and a PWM1 as well but this is not shown. The data says that.......
"C5 can be used with the pwmout command, but will make this pin an output.
Pins C2-5 (hpwm A-D) can all be used with the hpwm command, but will also
make the corresponding pins outputs"
So I suppose my question is "what's the difference between PWM and HPWM and could I use a 14M to drive a small motor one way and then the other using pwm on two of these outputs" ?
Rgds,
Sid