I am using the above config. If I attempt to output to (say) pin B.4 it does not appear on the output panel, which only shows pins 0-7. I have set my PIC type correctly etc.
How do I get it to recognise the M2 pin numbers?
Thanks
John
I have just purchased Logicator V5. I have loaded it onto an XP system and I have .Net 1.1 installed. When I run the application I get the following error:
An application exception has occurred that could not be handled.
Process id=0x350(848), thread id=)Oxec8(3784)
At this point the...