servodriver
Member
Hi all,
I am getting back to the Picaxe world after a few years, with the idea to control servos on my railroad.
But, I can not program any chips. I already had a AXE027 cable, and chips, and the programming setup is fairly simple;
should work, but now I suspect some simple error on my hand.
I have installed driver as per instructions,
loop test passes, which should indicate drivers work,
22k/10k setup chacked and rechecked,
tried hard reset, with no result,
also tried other chips.
Now I'm out of ideas...... what did I miss ?
Appreciate any suggestions.
Peter
I am getting back to the Picaxe world after a few years, with the idea to control servos on my railroad.
But, I can not program any chips. I already had a AXE027 cable, and chips, and the programming setup is fairly simple;
should work, but now I suspect some simple error on my hand.
I have installed driver as per instructions,
loop test passes, which should indicate drivers work,
22k/10k setup chacked and rechecked,
tried hard reset, with no result,
also tried other chips.
Now I'm out of ideas...... what did I miss ?
Appreciate any suggestions.
Peter