Hey guys
I hope someone can give me some good advice.
I have made a timer program where I used an AXE033 SERIAL I2C LCD to display the hours and minutes that I select via the readadc command.
in the program I have written the command:
"if pinB.1 = 1 then goto INDTASTMIN"
and
"if pinB.2 = 1 then goto STARTTIMER
My problem is that it works on the simulation, but when I run the program on my test board then run the whole program WITHOUT waiting for me to type 1 in the command "if pinB.1 = 1 then .....
All inputs "1" and "0 are ignored !!!
See the program and the picture.
I hope someone can tell me what's wrong
Best regards
Mejlby
Denmark
I hope someone can give me some good advice.
I have made a timer program where I used an AXE033 SERIAL I2C LCD to display the hours and minutes that I select via the readadc command.
in the program I have written the command:
"if pinB.1 = 1 then goto INDTASTMIN"
and
"if pinB.2 = 1 then goto STARTTIMER
My problem is that it works on the simulation, but when I run the program on my test board then run the whole program WITHOUT waiting for me to type 1 in the command "if pinB.1 = 1 then .....
All inputs "1" and "0 are ignored !!!
See the program and the picture.
I hope someone can tell me what's wrong
Best regards
Mejlby
Denmark
Attachments
-
713.6 KB Views: 10
-
647.2 KB Views: 10
-
12.7 KB Views: 4