fritz42_male
Senior Member
Hi all,
I've just built a 3 servo controller based on the 08M and proto board and it works fine and worked out at a cost of less then 5 quid!
Now, has anybody got a program that would allow it to interpret commands for a Mini-SSC?
I appreciate that I'd have to limit the baud rate etc but is it possible?
Thanks
Mike
I've just built a 3 servo controller based on the 08M and proto board and it works fine and worked out at a cost of less then 5 quid!
Now, has anybody got a program that would allow it to interpret commands for a Mini-SSC?
I appreciate that I'd have to limit the baud rate etc but is it possible?
Thanks
Mike