Technoman
Senior Member
Win 10 - PE6 6.1.0.0
Hi,
1) As I was testing a simple program (blockly) for a 20M2, as included, there was no sign of change on pins during simulation.
If I'm setting up any pin before the loop then it works fine, but only for this pin. Why?
2) I needed to get it run also on a board fitted with 20M. After switching between 20M2 and 20M, port B is renamed within the blocks to port C (?), but the simulation is correctly working on port B. Why? See file included.
Hi,
1) As I was testing a simple program (blockly) for a 20M2, as included, there was no sign of change on pins during simulation.
If I'm setting up any pin before the loop then it works fine, but only for this pin. Why?
2) I needed to get it run also on a board fitted with 20M. After switching between 20M2 and 20M, port B is renamed within the blocks to port C (?), but the simulation is correctly working on port B. Why? See file included.
Attachments
-
1.3 KB Views: 1
-
1.3 KB Views: 1