S SAborn Senior Member Dec 14, 2011 #1 What am i missing here with using the command....... settimer tls_8 ...... with the 20x2, as it tells me a unknown symbol tls_8, but as far as i can see the manual says this is a correct command.
What am i missing here with using the command....... settimer tls_8 ...... with the 20x2, as it tells me a unknown symbol tls_8, but as far as i can see the manual says this is a correct command.
S SAborn Senior Member Dec 14, 2011 #2 Ok i solved it as it is a 1 not a L, i looked and looked and it always read as a lower case L to me, had me a little miffed.
Ok i solved it as it is a 1 not a L, i looked and looked and it always read as a lower case L to me, had me a little miffed.
S srnet Senior Member Dec 14, 2011 #4 Someone will be along in a moment to suggest a change in the font used in the manuals ........
S SAborn Senior Member Dec 14, 2011 #5 Perhaps just an new set of eyes this end would help. Lets face it there is not many commands that use numbers, so i just seen it as a letter.
Perhaps just an new set of eyes this end would help. Lets face it there is not many commands that use numbers, so i just seen it as a letter.
premelec Senior Member Dec 14, 2011 #7 cw @g6ejd .---- clearly different than .-.. which is one reason I stayed with cw...
N nick12ab Senior Member Dec 14, 2011 #8 Or just a note pointing out that it's a 1 and not an l. I had to use the numbers shown for months before I realized that it was a 1 and not an l. 1 l 1 l 1 l
Or just a note pointing out that it's a 1 and not an l. I had to use the numbers shown for months before I realized that it was a 1 and not an l. 1 l 1 l 1 l
Technical Technical Support Staff member Dec 14, 2011 #9 timer_1_second = t1s we'll add a note in the manual, but many of the predefined constants do use numbers e.g. serout pin, N2400,("hello") etc.
timer_1_second = t1s we'll add a note in the manual, but many of the predefined constants do use numbers e.g. serout pin, N2400,("hello") etc.