I need to control two servos at once for the shoulder of a robotic arm so they need to move at exactly the same time and exactly the same degree turn. Im confused after reading the manual as it sais the servo command stops only when another servo command is reached or the pin is put high or low. does this mean I cannot control two servos at once? or should I connect both servos two one output of the picaxe (28x)? after testing this code:
main:
servo 1,75
pause 500
servo 2,100
pause 500
goto main
with the prog editor simulator it shows that pin 1 stays pulsed while pin 2 is pulsed also???
main:
servo 1,75
pause 500
servo 2,100
pause 500
goto main
with the prog editor simulator it shows that pin 1 stays pulsed while pin 2 is pulsed also???