Hi guys
Just read, and more importantly understood, the pullup command.
Added the code to be used on unused pins on 14 Picaxe's, 08M2,14M2 and 20M2, in VSM.
Syntax in PE showed all was well.
Ran the VSM schematic simulation and it runs but showed info in the Sim Log that pullup command not supported. It was not shown as an error.
Am I correct that it is irrelevant in VSM and will be fine on the real circuits?
Thanks
Angie
Just read, and more importantly understood, the pullup command.
Added the code to be used on unused pins on 14 Picaxe's, 08M2,14M2 and 20M2, in VSM.
Syntax in PE showed all was well.
Ran the VSM schematic simulation and it runs but showed info in the Sim Log that pullup command not supported. It was not shown as an error.
Am I correct that it is irrelevant in VSM and will be fine on the real circuits?
Thanks
Angie