Problem with AXE213 board


New Member
Hi. I am new to Picaxe and electronics in general. I am trying to get the AXE213 kit working.
The transmitter board will flash its LED correctly in test mode but I cannot get anything happening on the receiver board.

Using 2 Raspberry Pi's I have confirmed the transmitter and receiver modules are working. Using the RCSwitch library I can send and receive codes, and even send and receive from my 433MHz doorbell.

Can anyone advice on any tests I can do? Should a Raspi with a receiver module receive anything from the Picaxe transmitter board to check that side of things?
I realise that the Picaxe is using Manchester code so the RCSwitch software may not detect it.

All my soldering 'looks' ok, and the LED on the receiver is working.