PIC Programmer

Edlo · Jul 10, 2008

Can I use word variables when using the PIC Programmer. If so how? I have tried using w0 etc (b1:b0) but the programme crashes when I assemble. The software works OK if I simulate on screen using PICAXE.
eg symbol mem1=w0
mem1=0 (at this point assembler software crashes)
mem1=mem1+1 (again assembler crashes) etc

eclectic · Jul 10, 2008

If it's for the BAS800, then have a look at post #2, in this thread

http://www.picaxeforum.co.uk/showthread.php?t=3801&highlight=assemb*+command*

It might be easier to post subsequent queries in the main active Forum.

e

PIC Programmer

Edlo

New Member

eclectic

Moderator