Logicator V5 with Picaxe 18M2 pin assignments

[John Wollage]

I am using the above config. If I attempt to output to (say) pin B.4 it does not appear on the output panel, which only shows pins 0-7. I have set my PIC type correctly etc.

How do I get it to recognise the M2 pin numbers?

Thanks

John

 

[Technical]

In Logicator the 18M2 is set to portB as outputs and PortC as inputs, so outputs 0-7 already correspond to B.0 to B.7

 

[John Wollage]

OK I understand, but what if I want to output to a PortC pin, how do I address it?

 

[Tricky Dicky]

Use the Basic cell to output from PortC pins you will not be able to simulate this in Logicator as PortB and PortC pins are set as described by Technical.

Richard