L239D Motor Driver from Picaxe 28x1

MaltiK

Member
Ok, I have three L239D's that I bought recently, as well as four GM10 Geared Pager motors. Ok, I want to be able to control, based on "high ___" "low ___" coding, when the pager motors (3) are going to turn on, how many times etc. How will I do this, what will the I/O pins/terminals on the 28x1 be? Also, I would like to use one of these GM10's for mounting on an SRF05 how will I do this?
 

BeanieBots

Moderator
One step at a time.
Step 1. Read the L293 data sheet.
Step 2. Read the interfacing manual.
Step 3. Ask a more specific question rather than a general "how do I do it".

Expalin clearly which bit of the manual you don't understand.
 

billintexas

New Member
You need to find the chart with the 293d that shows pairs of number ie 4 &6 or 5& 7.The chart breaks he forwrd left right reverse coast into like a tic tac toe chart. Then you just say hi 4,6 low 5,7 etc to make the motors go the way you want em. I/o pins out 7 is pin 28 out 6 is 27 etc.You really need to have all the diagrams etc to do what you are asking. Be more specefic as to what you can do and what you need help on.
 

westaust55

Moderator
@ billintexas,

welcome to the PICAXE forum.

The thread you have found is in fact around 7 months old - when Maltik had only been a member for a month and was in a steep learning curve.
 
Top