I have discovered that the outs are very low powered..
I have hooked up the 40x to a high power project board and can now feed in 12v to 4 of the outs. My question is, is the high voltage controlled by the darlington chip, or can I use a separate circuit based on mosfets to ramp up the power to any number of outs and run them all off a separate supply in otherwords create a larger version of the 18x high power board? I would assume its just a scaled up version, but if its too hard.. oh well...
Some kind of schematic with explanation would be nice.
thanx
outfoxed again...
I have hooked up the 40x to a high power project board and can now feed in 12v to 4 of the outs. My question is, is the high voltage controlled by the darlington chip, or can I use a separate circuit based on mosfets to ramp up the power to any number of outs and run them all off a separate supply in otherwords create a larger version of the 18x high power board? I would assume its just a scaled up version, but if its too hard.. oh well...
Some kind of schematic with explanation would be nice.
thanx
outfoxed again...