AXE091 Development Board

Anobium

Senior Member
I have a few queries regarding the AXE091 dev board for @Technical et al.

What modifications are required/recommended to the AXE091 to support the newer M2 chips?

So far, I have had to add two caps and remove a resistor. The caps are to the 8/14 power pins and the resistor is connected to the 18 reset pin.

Anything else required? Is there a later AXE091 motherboard in production? Or, is this just me modifying the board?

Best regards,

Anobium
 

Technical

Technical Support
Staff member
No modifications are required at all.

Yes the 18M2 has a reset switch, but you can use this as a general purpose input on C.5
 
Top