AXE091 Development Board


Senior Member
I have a few queries regarding the AXE091 dev board for @Technical et al.

What modifications are required/recommended to the AXE091 to support the newer M2 chips?

So far, I have had to add two caps and remove a resistor. The caps are to the 8/14 power pins and the resistor is connected to the 18 reset pin.

Anything else required? Is there a later AXE091 motherboard in production? Or, is this just me modifying the board?

Best regards,



Technical Support
Staff member
No modifications are required at all.

Yes the 18M2 has a reset switch, but you can use this as a general purpose input on C.5