The bear
Senior Member
Hello Everyone,
Help required with my "Analogue Calibration Board" please. Link; PIC Analogue Calibration (75% off) (picaxestore.com) (Out of stock).
The problem; It's loading the circuit under test (Picaxe light sensor 08M2 pin C.4).
With nothing connected to the Analogue Calibration Board, Using an ohm meter on the three connections; 0v to I/P = 1388 ohms & +5v to I/P = 853 ohms. It makes no difference which way the meter leads are connected.
The thread below is too clever for me:
Any suggestions appreciated.
Bear..
Picaxe Analogue Calibration Board - replacement firmware
Picaxe Analogue Calibration Board - replacement firmware Thread starterAnobium Start dateApr 23, 2018
Help required with my "Analogue Calibration Board" please. Link; PIC Analogue Calibration (75% off) (picaxestore.com) (Out of stock).
The problem; It's loading the circuit under test (Picaxe light sensor 08M2 pin C.4).
With nothing connected to the Analogue Calibration Board, Using an ohm meter on the three connections; 0v to I/P = 1388 ohms & +5v to I/P = 853 ohms. It makes no difference which way the meter leads are connected.
The thread below is too clever for me:
Any suggestions appreciated.
Bear..
Picaxe Analogue Calibration Board - replacement firmware
Picaxe Analogue Calibration Board - replacement firmware Thread starterAnobium Start dateApr 23, 2018
- Thread starterAnobium
- Start dateApr 23, 2018