Hi, not sure if this is the right place for this question but...
the manual states that it is not possible to test i/p from two different ports in one 'if' command.
therefore am i right in thinking that ' if portA pin2=0 and pin3=1 then jump' should test pins 2 and 3 of portA?
when ran in simulator, its pin 3 of portC that affects the 'if' statement and not pin 3 of portA
am i doing something wrong or is there a bug?
the manual states that it is not possible to test i/p from two different ports in one 'if' command.
therefore am i right in thinking that ' if portA pin2=0 and pin3=1 then jump' should test pins 2 and 3 of portA?
when ran in simulator, its pin 3 of portC that affects the 'if' statement and not pin 3 of portA
am i doing something wrong or is there a bug?