michael boyd
Member
hi
I have a 21 channel servo driver module which I have installed a 18x picaxe chip.
My query is how do I download to it?
the module has Tx, Rx,Attn and Gnd. The picaxe has serial out, serial in and 0v.
How do I connect it up or is there an easier way?
Another question
In my project, it is powered by a few small power packs of different voltages. For example with the above module a 5 volt plugpack which runs the picaxe and a 6 volt to run the servos. My question is should all the negatives be connected?
regards
michael
I have a 21 channel servo driver module which I have installed a 18x picaxe chip.
My query is how do I download to it?
the module has Tx, Rx,Attn and Gnd. The picaxe has serial out, serial in and 0v.
How do I connect it up or is there an easier way?
Another question
In my project, it is powered by a few small power packs of different voltages. For example with the above module a 5 volt plugpack which runs the picaxe and a 6 volt to run the servos. My question is should all the negatives be connected?
regards
michael