Search results

  1. I

    Higher Wattage 12v Card LED strobe unit

    Hi Forum, I have created a 12v 4-6w LED strobe unit from a diagram- works good, however I need to hook up to 4 x 10 W LEDs on a 12v system (car). (Relay/ mofset?) what is e best way to do this (note the LEDS are in separated by about 4-8ft)
  2. I

    any guides to what this component is

    Hi Forum, I must have purchased this many moons ago- but I have no idea what it is - I think some pressure sensor - any guides?
  3. I

    IR question

    I am looking to setup an IR Transmitter and receiver for a model/s control project, its a pretty simple setup. I was hoping to control a number of models with the the same IR transmitter - but i am making some assumptions here: FYI - Create PICAXE transmitter...(not sony etc..) Questions...
  4. I

    AXE027 driver issue W7 64bit ultimate

    Hi Forum, I have tried installing the drivers for win7 (manually and via setup) with no joy I followed the instructions via pdf for the driver install but what i was seeing did not match the instructions: i dont get a driver install warning - just a driver did not install correctly...
  5. I

    Help with PCB software

    Dear Forum, I am looking at using CopperCam or EagleDesign Lite to create my pcbs on a Sherline mill via Mach 3 or direct . As i have zero experience with either products looking for some good information on these. PS i suspect i will also be working with SMD as well
  6. I

    PICAXE and servos

    Hi All, looking for some guides: I wish to control blinds using servos and picaxe (ps i have seen the blind controllers stuff) However my question relates to: can i control multiple servos (e.g. i have multiple blinds that i wish to operate in sync) and...... what if the get out of sync...
  7. I

    Surface mount Picaxe

    Hi Forum, I wondered what solutions are available to download to Surface mount Picaxe? I have the experimenter kit but it does not appear to have SM capabilities , what do most of you do in this situation?
  8. I

    Some advice for a PicAxe amateur

    Dear all need some advice on crating a 'solution' using PicAxe I want to create a 'setup' for the following: create 3 strobe lights (LED) (independent sequence for each) control 2 motors using PWM (start up, run and shutdown / motors will run at differing speeds) landing lights operation...
  9. I

    Sound effects circuit

    Hi Forum, Need some advice on sound circuits. i look to create sound effects for a hobby project which will be ultimately controlled by PICAXE. basic guide of parameters: seeking for reasonable good sound quality (will add mixer and AMP later) 16bit....stereo preferred MicroSD card...
  10. I

    PCB sensor advice for PICAXE

    Dear Forum, I seek a pressure (water) sensor which will work with picaxe. Application is reasonably strait forward: Submersible (or at least the sensor) 0-5m water depth small as possible low voltage calculating the depth via bottom distance will not work in my application, however...
Top