Search results

  1. S

    Porta problems

    i have a problem using a 28x, i am using the readadc10 command and i am using the picaxe28 starter kit for programming, i find it easier than using the pic programmer.. using version 4.1.15 upgrading as we speak code.. if porta pin2 =1 then ttripa if porta pin2 =0 and thermal =1 then ttripa...
  2. S

    Programming hang ups

    Is there any way that a picaxe28x can be reset if its programme gets lost without the use of the hard reset. is there any means of programming within the picaxe system that will detect a hung programme and reset it. i am having a lot of problems with this especially after using the programme...
  3. S

    readadc10 incorrect function of output pins

    i am using the readadc10 feature to read a voltage from 0v to 2.5v At 0.375V say adc10 77 i require the pic to turn on o/p 0 and stay on unless the level falls below 0.3v adc10 61 the output should flash, also at 2.5v adc10 512 i require output 1 high., at the low end it all works fine but once...
  4. S

    pwmout error message

    I am using a 16f872 and every time i try to programme with the pwmout and change basic to assemble a message comes up saying pwmout is not supported in this mode??? new new all this tried every option in the option tab, but still nothing will work...help please
  5. S

    erase problems with 16f76

    I am new to all this. i have purchased a pic programmer from www.tech-supplies and using a 16f76 chip. i cannot seem to check this device is blank or erase it..any ideas on what is going on, i have tried lifting pin 24 but still no joy. does the picaxe programme cater for this chip????
Top