Recent content by stan74

Great cow basic shows assembler for pic/avr from basic code and lets it be modified, It is a compiler not an interpreter.

Good stuff. Nice to have the time... I look on the bright side :) Take care,

That's tidy... like all the stuff you do... but a servo controller board is all servos sort of simultaneous and uses 2 pins clk,data. The guy who posted this has been on another forum and said polulo servo controller boards are good but I think ebay is always cheaper. Regards stan

I remember meccano as a kid and I'm 67 now. Got a load of all the bits and motors cogs nuts and bolts for your 5 bucks from what we call a charity shop. I think you call them thrift shops. Lots of handy bits and bobs! Steel is heavy though. We don't have Walmart here, we got screwfix... honest...

Using a 16 channel servo controller and a board with 2K ram and 16MHz... which in pic terms would be 64MHz. I needed 2 servo controllers to use 18 servos... wasteful. I could have done this with a 18f25k22...1.5k ram. Using the 16 channel servo controller takes all weight off a picaxe.. it does...

I never got a self balancing robot to work....cos I'm a lazy sod and give up too easily

far much too out erco ! :)

I posted it on facebook amazing. cheers.

PIC18F45K22 ....is that 40x2 as 28x2 is pic18f25k22? have you ubiquitous cap across vss and vdd why does it have 2 v+ and gnd ?

Hi guys, what's 28x2 scope about please? I tried making a "scope" but no analogue hardware just take a-d samples and display. Was this a project? seems a long time since someone mentioned it.

Tried this but without result: main: high b.1 'push TX speaker out delete-!!pulsout b.1,200-- It is supposed to self resonate at it's natural freq 'generates a 2 ms pulse delete-!!low b.1 'let speaker resonate at38 khz NOT stop it by making lo pulsin b.1,1,b1 if b1>0 and b1 < 10 then high b4...

I did the picaxe ssd1306 setup years ago...and the line draw. https://picaxeforum.co.uk/threads/picaxe-tron.29727/ The rest..ie circle--use mid point not trig boxes and triangles are lines joined. cls is write bytes to screen. I tried to do a faster line code than gcb but couldn't beat it...

I uses pulsin so get a value that represents distance. it has to be converted to mm. but use the actual value instead. #define echo = portB.1 ;ultrasonic sensor trig pin.echo pin joined to trig by 1.8k resistor. range is a word value ping: retry: dir echo out set echo on dir echo in pulsein...

so long, and thanks for all the fish....hitch hikers guide to the galaxy ...like cheers for the help guys, you been brill. I get your point and think you picaxe guys are very helpful same as other forums and I like to help even if no thank you. some like to help and share..and thanks can mean a lot.

I just used the picace rs232 to 3.5 jack plug and never got port problems. I've not binned it all and have erased picaxe chips and they work perfect as native pics... Bit of a waste though I thought. 8bit chips are useful for lots of stuff,It's just what you want them to do...like work in your...