Rampz's latest activity

  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    David yep thats normally how its done, certain details are obtained about the clock in question, i don't know what is asked, but the 15...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Thanks David, the prefered method is to pre set as much as possible leaving the client to set the angle onsite, we prefer to keep people...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Yep just my feeling not much angle to work with, the manufacturer wanted the smaller angle the better he said then the motor can trigger...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Just another thought, just been looking at rotary encoder incremental type, seem to give pluses out on 2 pins allowing direction to be...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Hippy yep i will try that in the first instance and see if i get anything either useful or repeatable. I think regards the rig i will...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Phil that's the problem I guess getting a snap action when the whole assembly rotates, only really have gravity to go against, the floor...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Thank you papaof2 i was half worried about vibration with the test rig since the motor didn't run too smooth at its slowest speed, on a...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    rq3 I am sure your right but need to start somewhere, it seems its got a reprogrammed output I can use, I don't have any experience with...
  • Rampz
    Rampz reacted to rq3's post in the thread Tilt switch test rig with Like Like.
    @Rampz, my gut feeling is that the MLX90371 might really complicate things. It is capable of three axis sensing, including an analog (or...
  • Rampz
    Rampz reacted to Goeytex's post in the thread 433 MHz issue ! with Haha Haha.
    I once left a cheap 433 MHz ASK module on in the lab overnight. The next morning I looked out the window to see the next door neighbor...
  • Rampz
    Rampz reacted to Mitch01's post in the thread Kitronik Music Box Upload of Tune Issue with Like Like.
    Hi, Sorry for only just replying, it has been very busy. I just wanted to thank you for all your help. I input the code that you...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Ok i have revised my interface board i have removed the alternating pulsed DC setup, since the general feeling thats its over kill and...
  • Rampz
    Rampz reacted to PhilHornby's post in the thread Tilt switch test rig with Like Like.
    Probably :) (Though just to be clear, C.2 is the only PWM output pin directly supported by the Picaxe firmware).
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    I just wonder if the very very slow speed that i am tilting will it will sense it or not, the motor on the chiming side of the clock...
  • Rampz
    Rampz replied to the thread Tilt switch test rig.
    Phil yes looks like magic code, i would say i'm better altering my pins to allow the use of C4, since i am already usings C0, Oh and...
Top