PieM's latest activity

  • PieM
    PieM reacted to erco's post in the thread Farewell with Like Like.
    @premelec: We are all saddened to hear that, you have been a steadfast pillar of this wonderful online community, and you have helped...
  • PieM
    PieM replied to the thread Farewell.
    Many thanks and best wishes.
  • PieM
    Non! mais les : correspondent à un passage à la ligne pour une autre instruction. C'est identique à temper = -temper signe = 45
  • PieM
    Bonjour, SI tu as 387, c'est que ta température mesurée est de 24.1 °C. Petit bout de programme qui te donne le calcul à faire: (il y...
  • PieM
    PieM replied to the thread Absolute encoder programming.
    No analog output on ATM22. See #2
  • PieM
    PieM replied to the thread Sim900 A6.
    100 nF is on the Picaxe. See manual... GND pin of the A6 and GND of the 28X2 must be connected. Always connect GND before VCC. Otherwise...
  • PieM
    PieM replied to the thread Sim900 A6.
    Hi, Alan is right. But "I assume "on the rail" refers to 28X2. " is wrong . It is used to stabilize voltage and power flow of A6 (>2A).
  • PieM
    PieM replied to the thread Problème avec interrupt.
    Moving doit se terminer par un return. Et pas de goto moving (qui renvoie sur Main !) dans l'interrupt mais gosub. Un peu emmêlé ce...
  • PieM
    PieM replied to the thread Problème avec interrupt.
    Sans programme ni boule de cristal, difficile de voir ...
  • PieM
    PieM replied to the thread Sim900 A6.
    "on the rail" means placing the 4700uF capacitor between Vcc and Gnd. You need two resistors to get 3.3V from 5V Pin17 output. And its...
  • PieM
    PieM replied to the thread Sim900 A6.
    On A6 Shield Development Board, supply voltage is 4.8 - 9V . A MP1584 step down converter give 3.3V to the A6. (Avoid USB supply from a...
Top