Does anyone know the time it takes for the chip to do an analog to digital conversion? I can't find it in the manual and the examples don't contain a pause statement.
I'm using a readadc command to read the voltage across a resistor to convert this into current to a motor. Can I assume that a...
Then manual says that the data stored by a write command are not lost during a power down. However, it's updated (with the EEPROM specified data) upon a new download.
I assumed this to mean that the data was NOT changed during a new download UNLESS an EEPROM command was executed.
I used this...
The description under the 'let' command says that negative numbers and parentheses are not supported and that the parsing works strictly from left to right.
Comment 1: The negative arithmetic actually works if you write the equation like:
temp = 0-12 + 15
The answer comes out 3, which is...
Would it be possible to broadcast an email to registered forum users when a new version of the editor is released? It seems like this would help everyone keep up-to-date and eliminate questions about obsolete problems...
Â
1. Minor nit. The Programming Editor Options Menu shows "256x gosub" for the 18X. The directive is "#gosubs 255". Is it 255 or 256? Please clarify in the manual when #gosubs is needed, apparently NOT when the "256x gosub" is selected.
2. Would it be possible...
I'm using an 08M to control two servos. The 08M is a slave to an 18X. The servo controls work perfectly except during high/low commands and if pin commands. I use these to handshake and pass data from the 18X. I've looked at it on a scope and the 20ms servo interval seems to be glitched...