Recent content by luger

I use h-bridge L239D. The servo works fine, but the motor cannot be controlled or stopped. As soon as I delete the code for the servo, the motor runs fine. I return the code for the servo and the motor cannot be controlled or stopped again. Mystery :)

ok I understand. so the correct way to run the code: Motor run, motor stop, servo run, servo stop etc.. I will end the motor control with the command, for example - low C.1 and low B.5 How do I properly end the servo command so that the timer allows the (PWM) motor to be controlled again...

Sorry, I was wrong in expressing and describing the problem. The Picaxe 40X2 has two internal timers. Or not? Step by step: Code 1: 1. the sensor switch on 2. the servo is running 3. servo stop Code 2: 1. switch another sensor 2. DC motor running (PWM) 3. motor stop The two codes run...

For the administrator: I'm not a robot! :) login confirmation not delivered (not even in spam) is my log active? what is wrong ? Thank you

Hi, I am a new member of this forum and I want to learn something to program and control Picaxe. Sorry for my english :) I have a 40X2 and I want to control two DC motors and three servos at the same time. Question: Which pins should I connect motors and servos to? I created two program codes -...

Hi, I am a new member of this forum and I want to learn something to program and control Picaxe. Sorry for my english :) I have a 40X2 and I want to control two DC motors and three servos at the same time. Question: Which pins should I connect motors and servos to? I created two program codes -...