I am using a 20M2 chip, does it matter if the serial in pin goes high or low during pic operation? it only states in manual 1 that you can not leave it floating.
Essentially what i want to do is use less ports on a connector to save board space, so as the IO goes on and off i need to be sure it...
Hello again Boffins
I have noticed from the M2 chips that the best possible resolution is only 8 bit from the ADC, I would prefer a speed control that could perhaps go up to 10 bit. Is there any possible way i can change the resolution from an 8 bit ADC input to a 10 bit (or anything better...
Hi there
I am designing an H-Bridge and learning a lot along the way, I have come up with a few questions I am hoping some of you can help me answer.
If I am sending a 5V 20Khz PWM signal from the PIC into a Mosfet, and to ensure that I do get the full PWM into the Gate of the Mosfet I want to...
i need to change the frequency of the 08M chip using logicator.
i know i need to use the Basic function straight after the Start and type in "SETFREQ M8".
But, i remember reading somewhere (probably one of the manuals) that i need to change the download frequency to 8Mhz as well, or i will...
Hi All
A few questions.
When is the 14M2 Launched?
I Need to charge stepper motor coils very quickly, the problem i have is the shortest wait is only 1ms. Is there a way this is possible using the 08M?
I have noticed a very short time delay when a GoSub procedure is called (I cant measure it...