kenmac's latest activity

  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy, The programming went well - all the data ended up in the FRAM. I passed your Python program on to one of our group who dabbles in...
  • K
    kenmac replied to the thread i2c problem.
    Hippy, Thanks, you are correct of course. I went back to the Manual again and found that it requires i2cword! I shall correct that...
  • K
    kenmac replied to the thread i2c problem.
    Allycat, It's OK - I only showed the code for the Eeprom. I used the correct address for the RTC. With a new chip, the registers will...
  • K
    kenmac replied to the thread i2c problem.
    Aries, I'm using a 24LC256 Eeprom. It will have all memory bytes as $FF when new (never programmed). It should work OK with bytes. kenmac
  • K
    kenmac posted the thread i2c problem in Active PICAXE Forum.
    Hi folks, I am about to load some data into a FRAM chip. so I decided to re-familiarise myself with i2c stuff. So, I made a small...
  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy, I know nothing about Python, but I can see what you have done here. I'm checking the data against the original, and if OK will...
  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy, I have now managed to recover the raw data file we need to be stored in FRAM. The file was generated many years ago by a DOS...
  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy, We have to delay sending the file to you because the USB stick is currently in the possession of one of our group from the...
  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy, Thanks for the offer. The file is 1.644 kB The transfer rate of the serial connection is normally 4800bd. FRAM writes can occur...
  • K
    kenmac replied to the thread USB data to FRAM.
    Hippy. Sorry, I misunderstood. The data is in the form of raw binary/bytes, comprising info to display a map on a radar screen. It...
  • K
    kenmac replied to the thread USB data to FRAM.
    I assume the data is in FAT32 format - it's just a standard USB stick. I have discovered an interface board called ALFAT which may do...
  • K
    kenmac replied to the thread USB data to FRAM.
    Is there a device/board that can read USB contents and be controlled by a Picaxe? kenmac
  • K
    Hi folks, I have a USB stick which contains a file of raw data (1.6kB). I want to use a Picaxe to read this data and write it to a FRAM...
  • K
    kenmac replied to the thread PE6 = no comm port found.
    Success! I did a driver update using the Zip file and it was successful. The PE6 is now displaying the Comms port in use. I must have...
  • K
    kenmac replied to the thread PE6 = no comm port found.
    The two methods I refer to was the two optional methods available. One was the direct installation file and the other was the Zip file...
Top